AKASA AK-CR-15BK External NFC Electronic ID and SmartCard Reader
AKASA AK-CR-15BK External NFC Electronic ID and SmartCard Reader
The AK9567 is a highly integrated single chip controller supporting Contact Smart Card along with an external NFC driver for dual interface, contact and contactless smart card readers. Through a standard SPI or I2C serial bus, it supports seamless interfacing with popular NFC controllers such as STMicroelectronics ST25R3916 series chips. It supports several international standards including ISO7816 for IC card standard, PC/SC 2.0 for Windows Smart Card standard, Microsoft WHQL and compliant with USB-IF CCID standard. AK9567 can generally be used to read/write to Smart cards on devices, like ATMs, POS terminals, public telephone, E-Commerce, personal use on the Internet, personal certification, etc.
Key features of AK9567
- Dual slot support: contact and non-contact
- SPI/I2C interface support for external NFC controller
- Contact card
- T0, T1 protocol support
- Support for ISO7816 Class A, B and C (5V/3V/1.8V) cards.
- I2C memory card support, SLE4418, SLE4428, SLE4432, SLE4442, SLE4436, SLE5518, SLE5528, SLE5532, SLE5536, SLE5542, SLE6636 and AT88SC1015, 5 AT45D041
- Contactless card
- Support for ISO14443 A, B and ISO15693 cards
- Compatible with Microsoft USB-CCID driver
- Performed as a full-speed USB device
- Built-in PLL for USB and Smart Card clock requirements
- Support for short APDU and extended APDU
- Supported card power supply current protection mechanism
- Firmware can be updated for external SPI flash via USB
Standard support
- Based on the implementation of ISO7816
- PC Smart Card industry standard support - PC/SC 2.0
- Microsoft Windows smart card reader driver support
- Compliant with Microsoft WHQL smart card reader certification
- Compatible operating systemsWindows 7, 8.1, 10 and 11
Linux
Android
macOS 10.14 and later
ST25R3916B is a high performance universal NFC device supporting NFC initiator, NFC target, NFC reader and NFC card emulation modes when applicable. Fully compatible with analog and digital EMVCo 3.1a, it is optimized for POS terminal applications and enables fast EMVCo certification cycles, even in harsh environments with antennas around noisy LCD displays.
Key Features of NFC ST25R3916B
- Dynamic Power Output (DPO) controls the field strength to stay within specified limits
- Active Wave Shaping (AWS)
- Noise suppression receiver (NSR) allows reception in noisy environments
- Automatic antenna tuning (AAT) via variable capacitor
- Integrated EMVCo® 3.1a compliant EMD handling
- Automatic reception control and squelch function to maximize SNR
- Active and passive NFC modes with low power consumption
- Adjustable ASK modulation depth, from 0 to 82%
- Integrated controllers to boost PSRR system
- AM/PM and I/Q demodulator with baseband channel summing or automatic channel selection
- Possibility to control two independent antennas
- Measurement of antenna voltage amplitude and phase, RSSI, on-chip power supply and regulated voltages
Other features of the NFC ST25R3916B
Operating modes
Reading/writing
Card emulation
Active and passive peer to peer
RF communication
Analog and digital compatible with EMVCo® 3.1a
NFC-A / ISO14443A up to 848 kbit/s
NFC-B / ISO14443B up to 848 kbit/s
Specifications
Features
Akasa Holland BV, De Donge 17, 5684 PX Best The Netherlands, [email protected]
Specifications can be changed without notice. Images are for illustrative purposes only.
