MAX1 Rear flasher Pop USB

MAX1 Pop USB is a lightweight rear USB flasher with COB LEDs and two mounting options - on the seat rails or on the seat tube. It offers 3 flashing modes and 3 illumination modes and achieves visibility up to 400 meters. The flashlight is charged via USB-C, with a charging time of 2.5 - 3 hours and up to 7 hours of operation on a single charge, depending on the mode selected and ambient conditions.

Dimensions:
3 × 4 cm (diameter × depth)

Weight:
29 g (including holder)

2 mounting options:
1. for seat tube - universal silicone-rubber holder - easy installation without tools
2. on the saddle rails - the holder is mounted with tie straps (included)

Charge status indicator:
charging - flashing
charged - lit

Low battery indicator:
light starts flashing - low battery

Lighting modes:
– 100% intensity
– 50% intensity
– 25% intensity

Flashing modes:
– 100% intensity
– 50% intensity
– 25% intensity

Control:
– holding the button for more than 2 seconds activates/deactivates the light
– Slowly press the button to switch modes in illumination or flashing mode
– mode change and flashing is done during operation by pressing the button twice quickly

Recommendations and information on the use of the light:
The batteries are memoryless, so feel free to recharge the batteries to the maximum after each use. If you run it down to the minimum, charge it as soon as possible. Storing a fully discharged light shortens battery life. If you do not use the light, the manufacturer recommends min. Check the battery in the light once every 3 months and recharge if necessary. The electronics completely control charging and discharging, including battery status indication, and protect the battery from overcharging or complete discharge. Keep the light under supervision when charging, do not cover it or place it on flammable materials.