Wurth Underbody protection and sealing against gravel - spray black 500 ml
Wurth Underbody protection and sealing against gravel - spray black 500 ml
Wurth underbody spray is designed for repairing and restoring original surface textures and for protecting against stone chips and corrosion on all visible areas, such as front and rear bumpers, side sills, bumper components and the underbodies of cars, lorries and buses. The product is also highly suitable as an anti-noise and anti-vibration protective coating for wheel arches and vehicle chassis. By changing the spraying distance or pressure, you can create various surface textures. The shade will darken after being coated with a clear varnish.
Key features of the Wurth underbody protection and sealant against stone chips - spray, black, 500ml
- Very good adhesion and fast surface drying
- Scratch-resistant
- Can be recoated with common solvent-based and water-based 1K and 2K topcoats
- Suitable for short-term drying at 40–60°C
- Sands very well after fully curing
How to use:
Shake thoroughly before use. The substrate must be clean, dry and free of rust and dust. For the first spray, apply a very thin layer to improve adhesion and let it flash off for approximately 3 minutes. Then apply another coat. Always allow each intermediate coat to flash off. Better spray results are achieved at a processing temperature of 15–25°C.
Please note:
Do not spray on joints, engines, gearboxes or brake systems. After use, turn the can upside down and spray the valve until empty. Do not mix the product with thinner, water or varnish. The product can be recoated within 24 hours of application. After this time, recoating is only possible after sanding and cleaning the surface.
Working pressure:
2–4 bar
Chemical basis:
Rubber
Optimal spraying distance:
30cm
Recommended application temperature:
15–25°C
Würth, spol. s r.o., č.p. 137. Nepřevázka 293 01, +420 323 041 141, [email protected]
Specifications can be changed without notice. Images are for illustrative purposes only.
