Würth PUR-polyurethane adhesive, transparent, 500 g

Typical applications

Würth PUR-polyurethane adhesive is used for typical applications such as: gluing windows and doors; boat building, internal and external construction, gluing of ladders and garden furniture (wood), bonding of sandwich panels made of polyurethane or polyester, hard foam with plywood or hard plastic boards (Duropal, etc. ), bonding of door frames and cassettes, stairs and railings, handles, gluing frames, balcony railings, garden furniture and fences, mounting connections, surface joints, plate joints and block bonding, joining MDF boards, stationary edge finish with veneer and solid wood strips, soft, hardwoods and exotic woods and particleboards, bonding of mineral building panels, ceramic materials, concrete materials and hard foams.

Use:
Apply PUR adhesive directly from the bottle or with a squeegee on one side on dust and grease free surfaces and on two sides for porous materials. One of the two materials must be absorbent. Remove any new adhesive splashes using a PU cleaner. Old adhesive residues can only be removed mechanically.

Technical specifications:
Chemical base: polyurethane
Density: 1,12 g/cm³
Colour: transparent/milk cloudy (hardened)
Min. the proportion of solids: 98 %
Min. film-making temperature: 5 °C
Viscosity: 3000 mPas
Conditions for viscosity: Brookfield
Stress Group: D4
Min. /max. moisture content of the wood: 8-14 %
Open hours: 15 minutes
Conditions for open drying time: at 20 °C and 150 g/m²
Min. pressing/solidification time: 60 minutes
Conditions for pressing/solidification time: at 20 °C
Min. pressing pressure: 0,1 N/mm²
Max. pressing pressure: 0,6 N/mm²
Min. /max. temperature resistance of the cured material: -30 to 100 °C
Min. /max. processing temperature: 10 to 20 °C
Application quantity for bonding surfaces max: 220 g/m²
Shelf life from date of manufacture: 12 months
Package contents: 467 ml

Storage:
Store in a cool, dry place.

Warning:
A preliminary test should be carried out to verify the required adhesion for a given design and wood type. In the case of ash wood, it is recommended to treat the substrate with Adhesion Plus for plastics/stone/wood. The oily type of wood must be glued immediately after processing to minimize the risk of a separation layer. The instructions for use are recommendations based on the manufacturer's own tests and experience. It is recommended that you perform your own tests before each use. Due to the wide range of possible applications and storage and operating conditions, the manufacturer is not responsible for the result of any given use. The manufacturer's free customer service department provides technical information or actions as an advisory service, it is not responsible for this service. This does not apply where such advice or information is provided in the context of specified, contractually agreed services or where the adviser has acted arbitrarily.